THE SPEC SHEET

THE SPEC SHEET

CAT STEERING CLUTCHES

Back to Tractorparts.com

Cat steering clutches can be measured by measuring the "stack heighth" of the discs .........all of them, the disc assemblies and the steel discs combined, while they are still assembled in the clutch group. Look closely at what you are measuring. The table below gives you measurements of what you would expect to measure when your discs are new and the stack heighth, minimal accepted, when you should replace the worn discs. When your clutch is disassembled, you will often find that not all the discs are worn equally so don't automatically assume you need to replace every disc in the clutch pack if the pack does not "measure up." If your measurement is "miminally acceptable" plan on rebuilding the clutch unless you just enjoy re-pulling and re-installing parts.

Models New Min. Acceptable

D2 3J/5J/4U/5U 2 7/8" 2 19/32"

D4 4G/7J/2T/5T/6U/7U 3 7/16" 3 3/32"

D4 40A 2.787"-3.092" 2.630

D6 2H 4 5/16" 3 11/16"

D6 4R/5R/8U/9U 3 5/16" 2 15/16"

D6 37A/44A 3.232-3.480" 2.938"

D6 74A/76A 2.008-2.190" 1.800"

D7 9G1--->6220 4 5/16" XX

D7 9G6221 and UP 3 5/16" XX

D7 7M/3T 2 3/4" 2 15/32"

D7 17A 2.750" 2.485"

D7 48A w/ .091 discs 2.536-2.802" 2.357"

D7 48A w/ .134 discs 2.923-3.189" 2.744"

D8 75/1H/8R 6 15/32' XX

D8 2U 4 31/32" 4 9/32

D8 13A 2.875" 2.280

D8 14A/15A Dry 3 7/32" 2 25/32"

D8 14A/15A Wet 4 5/16" 3 13/16"

D8 36A/46A 3 27/32" 3 9/16"

D9 18A/19A/34A 4.312" 3.750"

D9 66A 4.108-4.542" 3.750"